Introduction

[WIP]

Progress ​

What's done so far:

• Motor mounts, drive belts, gearing, torque curves for the "high" torque motors have gone through countless iterations of design and fault finding/stress testing.
• High RPM drive train pre-liminary requirements assessment  conducted.
• All electrical and electronic circuitry are way beyond their development phase, requiring minor firmware changes beyond this point.
• The board is functionally equivalent to a standard commercially available electric longboard.
• All hardware for front and read RGB illumination lights.
  

What's currently being done:

• Fault finding and stress testing -
  
  • Loss of signal with handheld remote results in Max regen request. 
• Optimizing High torque motor + BMS + Controller (ie: Start up torque, Current draw, battery cutoff, safety, range, feedback,etc)
• Working on controls for illumination lights 

What’s Left / What would be nice:

• Optimize for higher speeds
• Addition of a kick start function
  
• Selectable drive modes
  

​

Design Preview